Crane Equipment Maintenance six effective measures

Rope hoist maintenance - foot: the oil enough, enough water, enough air?
Diesel, petrol and air supply is not timely or interrupted, there will be start-up difficulties, poor combustion, power down, the engine will not operate cranes and other phenomena. If the oil supply shortage or disruption causes poor engine lubrication, the body badly worn or even Burnt phenomenon.
If insufficient cooling water will cause the machine temperature is too high, power down, increased wear and reduce service life.
2, Manual hoist  Maintenance - Inspection: that regular checks of fastening parts
Diesel and gasoline due to the course of the shock and vibration loads uneven impact, bolts, nuts easy to loose. There are various parts of the adjustment bolts should be checked in order to avoid damage to the body due to loosening of the accident.
3, crane maintenance - net: the net oil, net water, clean air and the body net
Diesel and gasoline engines are the main fuel crane, if diesel, gasoline is not pure, precise fit body will wear, with the gap increasing, causing oil spills, drip, fuel pressure is reduced, the gap becomes larger, and even cause oil clogged axle Burnt other serious faults. If the air Contains large amounts of dust, will accelerate the cylinder, piston and piston ring wear. If the cooling water is not pure, would Cooling scale blockage, obstruct crane engine cooling, lubrication conditions are poor, the body badly worn. If the appearance of the body without a net, make the surface from corrosion, shorteningLife.
4, crane maintenance - use: that is the proper use of the crane engine
Before driving, make sure that these parts are lubricated bearing and other lubrication. After starting the water temperature should be reached 40 ℃ -50 ℃ again when put into operation. Prohibited prolonged overload or low speed operation. Stop, before relieved loads reduce speed. After stopping the water temperature in winter should be dropped to 40 ℃ -50 ℃, put
You have a net cooling water injection engine antifreeze except slips. Usually have to do regular engine maintenance work to make the crane engine is always kept in good running condition. To ground observation, ground inspection, found fault, and remove.
5, load chain  Maintenance - grinding: the run-in
This is the basis for long life, whether it is a new car or overhauled engine must be run according to the rules after being put into normal operation.
6, crane maintenance - tune: that diesel or gasoline engine valve clearance, valve timing, injection timing, injection pressure and ignition timing, etc. should be checked and adjusted to ensure that the crane engine always in good technical condition in order to save fuel, extend the use of Life.